Enecsys Single Repeater Información técnica Pagina 26
- Pagina / 40
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
26 Installation and Operation Guide Enecsys LLC • 275 Redwood Shores Drive • Redwood Shores, CA 94065 • www.enecsys.com
6.3. Connections
T-Cabling System
1 AC connection per inverter to the T-cabling system to
create a branch circuit.
Table 3. Micro inverter AC connector pin out
United States Europe & Australia
Roof Surface
Inverter logo side facing roof surface
T Drop Cable Connector
receptacles
1 and 2 should
match pins 1
and 2 of
inverter
Inverter pins 1 and 2 facing roof surface
T Drop Cable
Connector
orientation:
“ALTW”
toward
roof
surface
Connector
“ALTW”
Side
Pin 1 L1 black L (TBD)
Pin 2 L2 red N (TBD)
Pin 3 N/A N/A N/A N/A
Pin 4 N/A N/A N/A N/A
equipment ground green equipment ground green/yellow
6.3.1. T-cabling AC connection
T-Cabling Systems: connections from the cabling to the micro inverters
Remove the protective caps from the T-cables immediately prior to connection to the micro
inverters.
1
2
3
4
5
6
7
4
b
4
a
Connect theT-cable AC drop connec-
tors to the inverter AC connectors.
!
WARNING:
All electrical connectors must be dry before making any connections and must
be kept dry during the installation process. Inverter AC cables are supplied with
protective end caps that should only be removed immediately before making
the connections.
1
2
3
4
5
6
7
8
9
4
b
4
a
PROTECTIVE CAP
Insert removal tool:
Push until it clicks
Remove protective cap
and discard
!
ATTENTION
To avoid damaging the inverter or cables,
do not force together the AC drop cable and
inverter AC connectors. The connectors are
keyed to prevent misalignment.
ATTENTION
For the cabling to be installed correctly, the AC
cable connections must be fully engaged. If they
are connected properly, you will hear an audible
“click”.
- Enecsys Enables 1
- Contents 2
- 1.1. Audience 4
- 1.4. Safety 5
- Gateway scope of delivery 9
- • 1 Enecsys Gateway 9
- 3.1. Mounting the gateway 10
- 3.2. Connecting the gateway 10
- ETHERNET CABLE 11
- ETHERNET 11
- 4.1. Enecsys Gateway Setup 12
- Step 1. Choose language 12
- Step 4. Set date and time 13
- Navigate to: 15
- Figure 9. Inverter Settings 17
- Figure 10. Gateway Settings 17
- Figure 11. Repeater Settings 17
- This screen is 18
- ATTENTION 19
- 5.2. Using Repeaters 20
- Figure 16. Enecsys Repeater 21
- Figure 18 22
- Chapter 6 Installation 24
- WARNING: 26
- Weatherproof Cap Female 27
- ATTENTION: 28
- 6.3.2. Cable Joiner 28
- Section Details 32
- Chapter 8 Troubleshooting 38
- 8.3. Monitoring 39
- Example : 40
Relacionado con productos y manuales para Puentes Y Repetidores Enecsys Single Repeater
(37 paginas)Sharp Hornos manuales de usuario
Empezando en K
Comentarios a estos manuales