Enecsys Single Repeater Guía de instalación descargar pdf (Pagina 17)

Installation manual Intelligent Reliable Power

5.1 Installing and connecting the AC Bus cabling

Caution: Attention: Ensure that a waterproof end-cap is used to seal any unused connection

points remaining open on the last AC distribution connection box.

Warning: Attention: Dependant on the model used, the maximum number of Micro-inverters

in any AC branch circuit must not exceed the maximum allowed.

FIGURE 4. Typical AC bus connection.

Any number of radial branches, up to the maximum number of inverters allowed.

Each inverter has one AC branching cable with pre-attached connector. This AC branching cable

has a nominal length of 900 mm and is terminated with a three pin connector.

AC CONNECTION

FROM MICRO-INVERTER

END CAP

DISTRIBUTION CONNECTOR

AC BUS EXTENSION

AC CONNECTION

FROM MICRO-INVERTER

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

Sin comentarios

Enecsys Single Repeater Guía de instalación Pagina 17